PLANET IP67-rated Industrial L2+, Håndtert, L2+, Strøm over Ethernet (PoE), Kan monteres på vegg

6-port 10/100/1000BASE-T waterproof and dustproof M12 X-coded female connectors with 4-port IEEE 802.3at/af Power over Ethernet Injector function  Power over Ethernet: Complies with IEEE 802.3at Power over Ethernet Plus/end-span PSE Up to 4 IEEE 802.3af/802.3at devices powered Supports PoE power up to 36 watts for each PoE port (Port 3 to port 6) Auto detects powered device (PD) Circuit protection prevents power interference between ports Remote power feeding up to 100m PoE management features PoE admin-mode control  PoE management mode selection PoE Legacy mode selection PoE Budget setup option Per port PoE function enable/disable PoE port power feeding priority Per PoE port power limit PoE Port Status monitoring PD classification detection Sequence port PoE Intelligent PoE features Temperature threshold control PoE usage threshold control PoE extension PoE schedule PD alive check LLDP PoE Neighbors  Industrial Protocol: Modbus TCP for real-time monitoring in the SCADA system IEEE 1588v2 PTP (Precision Time Protocol)   Industrial Case and Installation: IP67-rated aluminum case  DIN-rail or wall-mount design 12~56V DC, redundant power with reverse polarity protection Supports 6KV DC Ethernet ESD protection -40 to 75 degrees C operating temperature   Layer 2 Features: Prevents packet loss with back pressure (half-duplex) and IEEE 802.3x pause frame flow control (full-duplex) High performance of Store-and-Forward architecture, and runt/CRC filtering eliminates erroneous packets to optimize the network bandwidth Storm Control support Broadcast/Multicast/Unicast Supports VLAN IEEE 802.1Q tagged VLAN Up to 4K VLANs groups, out of 4094 VLAN IDs Supports provider bridging (VLAN Q-in-Q, IEEE 802.1ad)  Private VLAN Edge (PVE) Port Isolation MAC-based VLAN IP Subnet-based VLAN Protocol-based VLAN VLAN Translation Voice VLAN GVRP Supports Spanning Tree Protocol IEEE 802.1D Spanning Tree Protocol (STP) IEEE 802.1w Rapid Spanning Tree Protocol (RSTP) IEEE 802.1s Multiple Spanning Tree Protocol (MSTP), spanning tree by VLAN BPDU Filtering/BPDU Guard Supports Link Aggregation 802.3ad Link Aggregation Control Protocol (LACP) Cisco ether-channel (static trunk) Maximum 3 trunk groups with 2 ports per trunk group  Up to 4Gbps bandwidth (duplex mode)  Provides port mirror (1-to-1) Port mirroring to monitor the incoming or outgoing traffic on a particular port  Loop protection to avoid broadcast loops Supports ERPS (Ethernet Ring Protection Switching) Compatible with Cisco Uni-directional link detection (UDLD) that monitors a link between two switches and blocks the ports on both ends of the link if the link fails at any point between the two devices Link Layer Discovery Protocol (LLDP)  Provides ONVIF for co-operating with PLANET video IP surveillances Layer 3 IP Routing Features: Supports maximum 8 static routes and route summarization IPv4/IPv6 software static routing  Quality of Service: Ingress Shaper and Egress Rate Limit per port bandwidth control 8 priority queues on all switch ports Traffic classification IEEE 802.1p CoS IP TOS/DSCP/IP precedence IP TCP/UDP port number Typical network application Strict priority and Weighted Round Robin (WRR) CoS policies Supports QoS and In/Out bandwidth control on each port Traffic-policing on the switch port DSCP remarking Multicast Supports IPv4 IGMP snooping v1, v2 and v3 Supports IPv6 MLD snooping v1 and v2 Querier mode support IPv4 IGMP snooping port filtering IPv6 MLD snooping port filtering MVR (Multicast VLAN Registration) Security: Authentication IEEE 802.1x port-based/MAC-based network access authentication Built-in RADIUS client to co-operate with the RADIUS servers TACACS+ login users access authentication RADIUS/TACACS+ users access authentication Access Control List IP-based Access Control List (ACL) MAC-based Access Control List Source MAC/IP address binding DHCP Snooping to filter un-trusted DHCP messages Dynamic ARP Inspection discards ARP packets with invalid MAC address to IP address binding IP Source Guard prevents IP spoofing attacks IP address access management to prevent unauthorized intruder  Management: IPv4 and IPv6 dual stack management Switch Management Interfaces Web switch management Telnet Command Line Interface  SNMP v1 and v2c switch management SSHv2, TLSv1.2 and SNMP v3 secure access IPv6 IP Address/NTP/DNS management Built-in Trivial File Transfer Protocol (TFTP) client BOOTP and DHCP for IP address assignment System Maintenance Firmware upload/download via HTTP Dual Images DHCP Relay DHCP Option82 DHCP Server User Privilege levels control NTP (Network Time Protocol) UPnP Link Layer Discovery Protocol (LLDP) and LLDP-MED IEEE 802.3ah OAM Compatible with Cisco uni-directional link detection(UDLD) that monitors a link between two switches and blocks the ports on both ends of the link if the link fails at any point between the two devices Network Diagnostic ICMPv6/ICMPv4 Remote Ping Cable Diagnostic technology provides the mechanism to detect and report potential cabling issues SMTP/Syslog remote alarm Four RMON groups (history, statistics, alarms and events)  SNMP trap for interface Linkup and Linkdown notificationSystem Log PLANET NMS System and Smart Discovery Utility for deployment management