Brodit Active holder for fixed installation - Bilholder/lader for mobiltelefon

Active holder for fixed installation\n\n2A charger. Adjustable holder. Fits for devices with and without skin with the following dimensions: Width: 62-77 mm, Thickness: 6-10 mm. With Micro USB Type C charging cable.\n\nKeep your phone in a holder when on the road and you will always have it within easy sight and reach. The active holder for fixed installation is to be connected inside the dashboard, this gives a discreet, neat installation without cables hanging over the interior! This holder comes with a Micro-USB Type C charging cable. Fits phones with USB Type C charging inlet only. \n \nThe adjustable holder fits for devices with and without skin with the following dimensions: Width: 62-77 mm, Thickness: 6-10 mm. Adjustable holders come in various sizes. Measure your device and compare with the holder specifications in order to make sure you have chosen the correct product (if you are using a skin: measure the device with the skin in place). Before using the holder you need to set the holder's width so it suits your device, then your phone is held firmly in place in an upright position for maximum cellular reception. The holder has a neat and discreet design which blends well with the vehicle's interior. \n \n12 Volt. The product is E-approved. Connect the power cable with a 2A fuse. 2A charger, professional installation recommended. \n \nThe holder is made of black ABS plastic. It is easy to put the device into the holder, and just as easy to take it with you when leaving the vehicle. The holder is equipped with a tilt swivel so you can adjust the angle of your device in order to avoid light reflection on the screen. You can tilt the holder 22° in each direction. Attach onto ProClip Mounting Platform.